Addonics Technologies Computer Drive ADSAIDE44 User Manual

ADDONICS TECHNOLOGIES

Model: ADSAIDE44

Installation Guide

Front View

2. Connect the converter board to the SATA connector of

the hard drive.

44-pin IDE Connector

3. (Optional) Connect the IDE ribbon cable to the 44-pin

connector on the converter. The red edge of the ribbon

cable needs to line up to pin 1 marker of the 44-pin

connector. The other end of the ribbon cable will be

connected to your motherboard’s 44-pin IDE channel.

SATA Power and

Data Connector

Master, Slave &

Cable Select

Jumpers

Pin 1 Marker

Jumper Settings

Master

Note:

Slave

Cable Select

To set the SATA hard drive as a Master Device

when connected to an IDE channel, you need to

short the top pins located on the converter by

placing a jumper. As a Slave Device short the

middle pins.

1. Locate the SATA connector of your 2.5” SATA drive.

TECHNICAL SUPPORT

15-pin SATA Power &

7-pin Data Connector

Email:

Internet:

Technical Support (8:30 am to 6:00 pm PST)

Phone:

Email:

408 573-8580